HR680 Hydra Rig – Chain Elongation Measurement

Maximum Allowable Chain Elongation

The maximum allowable chain elongation is 3%.

If chain elongation exceeds 3%, the chain is considered unacceptable and may lead to:

  • Chain failure
  • Chain tension system reaching the end of its travel
  • Increased wear on the sprockets and skates

Measurement Procedure

  1. Clean the Injector and Chain thoroughly.
  2. Apply sufficient Chain Tension to keep the chain properly seated during measurement.
  3. Measure the outside distance across seven rollers. This measurement is L2.
  4. Measure the inside distance across six rollers within the same seven rollers. This measurement is L1.
  5. Calculate the Mean Length (ML):

ML = (L1 + L2) ÷ 2

  1. Calculate the Chain Elongation:

Chain Elongation (%) = [(ML − Original Length) ÷ Original Length] × 100

  1. Take measurements at two different locations on the chain to identify any localized wear.

Example

If:

Original Length = 381 mm
Measured ML = 385 mm

Then:

Elongation = [(385 − 381) ÷ 381] × 100

Elongation = 1.05%

Therefore, the chain elongation is approximately 1.05%

www.goscoenergy.com

Contact Us